ErgoPro m664-series PC Specialist's Handbook
Page 5-2 Edition 1 - Release 1 - March 1998
BIOS Power On Self Test (POST)
After the power has been turned on, the system performs a power on self-test, i.e. POST, to check that all parts
are working properly.
If the test does not find any faults you will hear one long beep. During the POST BIOS information is shown on
the screen:
PhoenixBIOS 4.0 Release 6.0
Copyright 1985 - 1997 Phoenix Technologies Ltd.
All Rights Reserved
4A4LL0X0.86A.0015.P05.9712111454
The message indicates the BIOS version (0015.P05).
The following pages describe the steps that you should take if either fault situation should occur.
To Next Page
Loading...
Need help?
General