Getting started
Switchingonforthefirst tim e: installing the software
Installing,Software,Installing,
Once the installation ha s been started the device m ust not be switched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the device is integrat
ed into a network, the user and server details as well as
the network pro toco l ar
e required during the software installation.
Contact your network ad
ministrator if you have any questions about these settings.
When you switch on the d
evice for the first time, the supplied software
is installed and config
ured. Plan a reasonable amount of time for this,
as this process m ust n
ot be interrupted.
Switch on the monitor and the machine
In order to avoid overheating, do not cover the ve ntilation areas
on the monitor or the device.
► Switch on the monitor (see operating instructions for the monitor).
► Press the on/off bu tton on the front of the machine.
The operational display will light up and the machine will start.
Fujitsu 29
To Next Page
Loading...
Need help?
General