Troubleshooting and tips
Troubleshooting and tips
Refer to the sa fety notes in the "Safety/regulations" manual and in the "Getting
started", Pa ge 13 chapter when connecting or disconnecting cables.
If a fault occurs , try to c
orrect it as described in the following documentation:
• in this chapter
• in the documentation for the conn ecte d devices
• in the help systems of th
e software used
• in the documentation for your operating system
Help if problems occur
Should you encount
er a problem with your computer that you cannot resolve yourself:
► Note the ID number
of your device. The ID number is found on the type rating
plate on the back,
the underside o r the top of the ca sing.
► Contact the Service Desk responsible for your country for clarification of the problem:
"
http://support.ts.fujitsu.com/contact/se rvicedesk". When you do this, please have
ready the ID number an d serial numbe r of your system.
Troubleshooting
Power-on indicator remains unlit after you have
switched on your device
Cause
Troubleshooting
The mains voltage supply is faulty. ► Check whether the p ower cable is plugged
properly into the device and a grounded
mains outlet.
Internal power supply overloaded.
► Pull the power plug of the device out of the
mains outlet.
► Wait app
rox. 3 min.
► Plug the power plug into a properly grounded
mains outlet again.
► Switc
h the device on.
Fujitsu 39
To Next Page
Loading...
Need help?
General