Troubleshooting and tips
The device cannot be switched off with the On/Off switch.
Cause
Troubleshooting
System crash ► Press the On/Off sw itch for at least
4 seconds, until the device switches off.
Attention: Warning, this could lead to a loss of
data!
The Operating System is not shut-down properly
in the process. Error messages are therefore
possible the next time the system is booted.
Monitor remains blank
Cause
Remedy
Monitor is switched off ► Switch your monitor on.
Power saving has been activated (screen is
blank)
► Press any key on the keyboard.
or
► Deactivate the screen saver. If
necessary, ente r the appropriate
password.
Brightness control is set to dark ► Adjust the brightness control. For detailed
information, plea se refer to the operating
manual supplied with your monitor.
Power c able not connected
► Switch off the monitor and the device.
► Check that the monitor power cable is
properly connected to the monitor and to
a grounded mains outlet or to the monitor
socket of the device.
► Check that the device power cable is
properly plugged into the device and a
grounded mains outlet.
► Switch on the monitor and the device.
Monitor cable not connected
► Switch of
f the monitor and the device.
► Check that the monitor cable is properly
connected to the device and monitor.
► Switch o
n t he monitor and the device.
Incorrect setting for the monitor
► Restar
t t he system.
► Press
F
8
while the system is booting.
► Start
the system in Safe Mode.
► Set up the monitor as described in the
documentation for your operating system
and monitor.
40 Fujitsu
To Next Page
Loading...
Need help?
General