4. Connection and Settings
Connecting to the Server UPS Unit
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Copyright 2019 FUJITSU LIMITED P3AM-8012-14ENZ0
56
2 Connect the AC sensor unit to the power synchronized unit with the AC sensor port connection
cable.
2-1 Attach the branch connector to the AC sensor output port of the AC sensor unit.
A branch connector is provided with the AC sensor unit.
2-2 Connect the AC sensor port connection cable to one of the ports on the branch connector that was
attached in Step 2-1
.
2-3 Connect the connector at the other end of the AC sensor port connection cable to the AC SENSOR port
on the power synchronized unit.
When connecting the AC sensor port connection cable, check the connector orientation and then firmly
push it all the way in.
When disconnecting the AC sensor port connection cable, hold the tab of the connector while pulling it
out.
AC sensor output port
Branch connector
AC sensor port connection cable
Branch connector
AC sensor port connection cable
AC SENSOR port
Power synchronized unit
To Next Page
Loading...
