Fujitsu ETERNUS AF Series - Page 68

Chapter 5 Adding a Connecting Device
5.2 Connection Procedure When Adding an ETERNUS DX/AF
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
68
2 Connect the ETERNUS DX/AF storage systems to the power synchronized unit.
An example of a connection between ETERNUS DX/AF storage systems and a power synchronized unit is
shown below.
For details about how to connect an ETERNUS DX/AF to the power synchronized unit, refer to "4.5
Connecting to the ETERNUS DX/AF" (page 61).
End of procedure
Power synchronization starts when the connection is complete. Check that power synchronization performs
normally.
Power synchronized unit
ETERNUS DX/AF #0
PWC
ETERNUS DX/AF #1
PWC
ETERNUS DX/AF #2
PWC
ETERNUS DX/AF #3
PWC
Added ETERNUS DX/AF
Added ETERNUS DX/AF
Added ETERNUS DX/AF
Server#0
UPS unit for
Server#0
Server#1
UPS unit for
Server#1
RS232C cables
(optional)
RS232C cable
(provided with a
power synchronized unit)
PWC#0 PWC#1 PWC#2 PWC#3