EasyManua.ls Logo

Fujitsu Eternus DX600 S3 - Default Chapter; About this Manual

Fujitsu Eternus DX600 S3
151 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preface
Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage
system (hereinafter referred to as ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes all the procedures that are required to start operation of the ETERNUS DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.
Fifth Edition
December 2014
About This Manual
Organization
This manual is composed of the following nine chapters:
"Chapter 1 Component Names" (page 18)
This chapter provides components names of the ETERNUS DX.
"Chapter 2 Checking the Configuration Environment" (page 25)
This chapter describes the environment required for system configuration.
"Chapter 3 General Settings" (page 33)
This chapter describes the basic settings for the ETERNUS DX.
"Chapter 4 Monitoring Settings" (page 62)
This chapter describes the settings required to monitor the ETERNUS DX.
"Chapter 5 Power Control Setup" (page 82)
This chapter describes the settings required for power control of the ETERNUS DX.
"Chapter 6 SAN Connection Settings" (page 86)
This chapter describes the settings required to use the ETERNUS DX with a SAN connection.
"Chapter 7 Advanced Copy Settings" (page 118)
This chapter describes the settings required to operate Advanced Copy.
"Chapter 8 System Status Check" (page 129)
This chapter describes the status check for the ETERNUS DX after system configuration.
"Chapter 9 Solution Configuration" (page 134)
This chapter describes storage solutions using the ETERNUS DX.
Registered Trademarks and Trademarks
All SPARC trademarks are used under license from SPARC International, Inc. and are trademarks or regis-
tered trademarks of that company in the United States and other countries.
UNIX is a registered trademark of The Open Group in the United States and other countries.
Microsoft, Windows, Windows Server, and Internet Explorer are either registered trademarks or trademarks
of Microsoft Corporation in the United States and/or other countries.
3
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0

Table of Contents

Other manuals for Fujitsu Eternus DX600 S3

Related product manuals