11 Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
4.2.3 Syslog Setup
If an event occurs in the ETERNUS DX, logs for the event can be sent to the specified Syslog server (external
server).
•
Up to two Syslog servers can be set.
•
Make sure to check whether the Syslog server receives logs correctly after the Syslog notification envi-
ronment setup is complete.
•
Logs are not sent again when a communication error occurs between the ETERNUS DX and the Syslog
server.
The Syslog setting is explained below.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [Network].
The [Network] screen appears.
3 In [Action], click [Setup Syslog].
The [Setup Syslog] screen appears.
4 In the [Setup Syslog] screen, set the required items.
• Select "on(RFC3164)" or "on(RFC5424)" for "Send Log".
To send messages in RFC5424 format to a target Syslog server that supports RFC5424, select
"on(RFC5424)". If this is not the case, select "on(RFC3164)".
Chapter 4
Monitoring Settings
4.2 Various Notification Settings
72
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
