4.2.2 E-mail Setup
If an event occurs in the ETERNUS DX, the event information is reported to the specified e-mail address.
•
Up to five e-mail addresses can be set.
•
Make sure to check whether the e-mail messages are received correctly after the e-mail notification en-
vironment setup is complete.
•
E-mail messages are not sent again when a communication error occurs between the ETERNUS DX and
the SMTP server.
The e-mail setting is explained below.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [Network].
The [Network] screen appears.
3 In [Action], click [Setup E-Mail Notification].
The [Notification E-Mail] tab screen of the [Setup E-Mail Notification] screen appears.
4 In the [Notification E-Mail] tab screen, set the required items.
• Select "Yes" for "Notification E-Mail".
• Enter the destination e-mail address or addresses for the Destination E-Mail Address fields.
5 Click the [E-Mail Server Settings] tab.
The [E-Mail Server Settings] tab screen appears.
Chapter 4
Monitoring Settings
4.2 Various Notification Settings
70
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
