5.3 Wake On LAN Settings
A network environment needs to be set to receive magic packets that are used by Wake On LAN for the ETER-
NUS DX.
The procedure to set Wake On LAN is as follows.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [Network].
The [Network] screen appears.
3 In [Action], click [Setup Network].
The [Setup Network Environment] screen appears.
4 In the [Setup Network Environment] screen, select [Enable] for [Wake on LAN].
• For operations with cluster connections, set the IP address of the Slave CM for the "Slave IP Address"
of the MNT port.
• To control power supply with servers in a network to which the ETERNUS DX does not belong, set
"Gateway" and specify the server IP address or the network address in "Allowable IP Address".
5 Click the [Set] button.
A confirmation screen appears.
6 Click the [OK] button.
The network environment settings are applied.
Chapter 5
Power Control Setup
5.3 Wake On LAN Settings
84
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
