Fujitsu Eternus DX600 S3 - Host Affinity Settings

3 Enter the host response name and set the required items. When ETERNUS Multipath Driver is used, the
TPG Referrals setting can be enabled.
Click the [Modify] button after the required settings are complete.
4 In the confirmation screen, click the [OK] button.
5 Click the [Done] button to return to the [Host Response] screen.
6.1.2 Host Affinity Settings
Use ETERNUS Web GUI to set host affinity.
Host affinity settings ensure security when multiple servers are connected by assigning the servers that can
access the volumes.
This section provides an example for setting host affinity by associating a host group, a CA port group, and a
LUN group when an iSCSI interface is used for connection.
Set host affinity in the following order:
•
Host group addition
•
Port parameter settings
•
CA port group creation
•
LUN group addition
•
Host affinity creation
For the settings for connection using other interfaces, refer to "Configuration Guide (Web GUI)". Also refer to
"Configuration Guide -Server Connection-" as required.
Chapter 6
SAN Connection Settings
6.1 Connection Settings for the ETERNUS DX
87
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0