6.1.2.1 iSCSI Host Group Addition
Add the information on the hosts (servers) that access the ETERNUS DX via the host interface port. Create a
host group when adding a host.
A host group is a group of HBAs that have the same host interface and access the same LUN groups.
The procedure to register a host group is as follows:
1 On the navigation of the ETERNUS Web GUI screen, click the [Connectivity] tab.
2 In [Action], click [Add iSCSI Host Group].
The [Add iSCSI Host Group] screen appears.
3 Specify a host group name to be created, and select a host response to be assigned to the host group.
4 Register an iSCSI host in a host group and click the [Add] button.
The following screen shot shows registration of a host by clicking the [Now Connected] tab.
A confirmation screen appears.
5 Click the [OK] button.
The iSCSI host group is added and the registration completion screen appears.
6 Click the [Done] button.
The screen display returns to the [Host Group] screen.
Chapter 6
SAN Connection Settings
6.1 Connection Settings for the ETERNUS DX
88
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
