Usage Protocol tcp / udp
Port
number
Direction
Master CM Slave CM
Remarks
MNT RMT MNT RMT
E-mail smtp (cli-
ent)
tcp 25 (*3) to
¡ (*2) ¡ (*2)
´ ´
Used for
failure
notifica-
tion, etc.
NTP NTP (cli-
ent)
udp 123 to
¡ (*2) ¡ (*2)
´ ´
−
REMCS
(remote support)
smtp tcp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
Used for
failure
notifica-
tion, etc.
http (cli-
ent)
tcp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
Used for
firmware
down-
load, etc.
AIS Connect (remote
support)
https (cli-
ent)
tcp 443 to
¡ (*2) ¡ (*2)
´ ´
—
Syslog
(event notification
and audit log send-
ing)
Syslog udp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
−
RADIUS Radius udp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
−
ping ICMP − − from
¡ (*2) ¡ (*2)
´ ´
−
KMIP (key manage-
ment)
SSL tcp 5696
(*3)
to
¡ (*2) ¡ (*2)
´ ´
−
ETERNUS DX Discov-
ery
Unique
protocol
udp 9686 from
¡
´ ´ ´
−
¡: Possible / △: Partially possible / ´: Not possible
*1: Only the following functions are available:
• Checking the ETERNUS DX status
• Switching the Master CM
*2: May use either the MNT port or RMT port.
*3: Modifiable
For details on the port numbers for the ETERNUS SF Software, refer to the manual of each Storage Foundation
Software ETERNUS SF.
■
Communication Modes
The default LAN operation mode is "Auto Negotiation" which allows the ETERNUS DX to automatically recog-
nize 1000Base-T/100Base-TX/10Base-T and Full/Half-Duplex connections. However, some devices may re-
quire that a fixed communication mode be set.
Chapter 2
Checking the Configuration Environment
2.4 LAN Connection Preparation for Operation Management
32
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
