4 In the [Setup Firewall] screen, specify whether to enable/disable each service.
To enable a service, select the checkbox for that service.
• HTTP/HTTPS
This service is enabled when an ETERNUS DX is connected via ETERNUS Web GUI.
Data is encrypted and transferred for HTTPS.
• Telnet/SSH
This service is enabled when an ETERNUS DX is connected via ETERNUS CLI.
Data is encrypted and transferred for Secure SHell (SSH).
• ICMP
This service is enabled when an ICMP connection is allowed.
• Maintenance-Secure
This service is enabled for connections from things such as monitoring software or for using the re-
mote support function to download firmware between storage systems.
SSH encrypts and sends/receives data.
• SNMP
This service is enabled when an ETERNUS DX is connected via the SNMP manager.
• ETERNUS DX Discovery
Change the setting to "Disable".
5 Click the [Set] button.
6 In the confirmation screen, click the [OK] button.
The firewall settings are applied.
7 Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
Chapter 3
General Settings
3.4 Firewall Settings
48
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
