3 Enter the name of the RAID group that is to be registered. Select "Manual" for "Create Mode".
4 Set the required items and click the [Create] button.
The following screen shows the settings that are displayed when creating a RAID group with the RAID
group name "RG0" and the RAID level "RAID5(4+1)".
A confirmation screen appears.
5 Click the [OK] button.
The RAID group is registered and the registration completion screen appears.
6 Click the [Done] button.
The screen display returns to the [RAID Group] screen.
7 After creating an operation RAID group, repeat Step 1 and later steps to create a backup RAID group.
The following screen shows the settings that are displayed when creating a RAID group with the RAID
group name "RG1" and the RAID level "RAID5(2+1)".
Chapter 3
General Settings
3.5 RAID Configuration Settings
51
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
