Warning Labels and Manufacturer's Labels
Warning labels, manufacturer's labels, and a device ID label are found in the ETERNUS DX, as shown in the
example below.
Never remove these labels from the equipment or allow them to become dirty.
ETERNUS DX500 S3/DX600 S3 (Controller Enclosures)
On the controller enclosure, warning labels and manufacturer's labels are attached to the rear or to the left
side.
•
When warning labels and manufacturer's labels are attached to the rear
Device ID label
The model name and the serial number are listed.
Manufacturer's label
The model name and the serial number are listed.
This label can be viewed by pulling out the label plate
when the controller enclosure is installed in a rack.
This label is attached on the label plate, which is located on the left rear
side of the controller enclosure. This label can be viewed by pulling out
the label plate when the controller enclosure is installed in a rack.
Preface
8
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
