2 In [Target portals], click the [Discover Portal] button.
3 In [IP address or DNS name] on the [Discover Target Portal] screen, specify the IP address of "CM#0
CA#0 Port#0" of the ETERNUS DX (C in Figure 6.1).
When the port number on the ETERNUS DX is changed, the value set in [Port] must be changed.
4 Click the [Advanced] button.
5 On the [Advanced Settings] screen, click the [General] tab.
6 Specify the following items under [Connect using].
Local adapter: Microsoft iSCSI Initiator
Initiator IP: IP address of the server (A in Figure 6.1)
When setting access restrictions, the settings related to CHAP authentication is required.
For details on CHAP authentication, refer to "Configuration Guide -Server Connection-".
Chapter 6
SAN Connection Settings
6.2 Server Connection Setup
97
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
