Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
119
5 In the [Setting based on Severity] tab screen, select the required items.
6 Click the [Error Severity Level] tab.
The [Error Severity Level] tab screen appears.
7 In the [Error Severity Level] tab screen, select the required items.
8 Click the [Warning Level] tab.
The [Warning Level] tab screen appears.
9 In the [Warning Level] tab screen, select the required items.
10 Click the [Informational Level] tab.
The [Informational Level] tab screen appears.
11 In the [Informational Level] tab screen, select the required items.
12 Click the [Set] button to apply the specified settings.
A confirmation screen appears.
13 Click the [OK] button.
The event notification settings are applied.
14 Check the setting completion message and click the [Done] button.
The screen display returns to the [Event/Dump] screen.
To Next Page
Loading...
