Fujitsu Eternus DX90 S2 - Figure 1.6 Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote Support Port Is Used)

Chapter 1 Preparation
1.1 Connection Preparation
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
22
• Connection example with a dedicated remote support port
- For the ETERNUS DX Disk storage system, three IP addresses are required (two IP addresses for the
MNT ports and one IP address for the RMT port).
To connect the ETERNUS DX Disk storage system to both an IPv4 network and an IPv6 network, an IPv4
address and an IPv6 address are required for each port.
- An IP address is required for a PC that is used for maintenance operations performed by a
maintenance engineer.
- Network devices such as LAN switches are required for operation management.
- Network devices such as routers are required for the remote support.
- Four enhanced Cat-5 twisted-pair type LAN cables are required (two for connection to the remote
support center and two for connection to the LAN for operation management).
Figure 1.6 Connection example when the IP address of the Slave CM is set (and a dedicated remote
support port is used)
Operation is performed with separate LANs for the MNT port and the RMT port.
The IP addresses of both the Master CM and Slave CM are set.
NTP server
Mail server
Authentication
server
Syslog server
LAN for operation management
LAN switch
Router
This PC is used for maintenance operations.
PC used for maintenance
ETERNUS DX Disk storage system
Controller enclosure
RMT MNT
CM#0
RMT MNT
CM#1
Remote support
center
Administration
terminal
SNMP
manager
IP address BIP address C
IP address D
IP address A