Fujitsu Eternus DX90 S2 - Chapter 5 Setup; Basic Setup; ETERNUS DX Disk Storage System and PC Terminal Connection; Figure 5.1 PC Terminal Connection for Initial Setup

ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
89
Chapter 5
Setup
This chapter explains how to set up the ETERNUS DX Disk storage system.
5.1 Basic Setup
Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX Disk storage system.
5.1.1 ETERNUS DX Disk Storage System and PC Terminal Connection
Connect a PC terminal to the ETERNUS DX Disk storage system.
Connect the PC terminal to the MNT port of Controller 0 (CM#0) on the controller enclosure directly with the
LAN cable (for operation management).
Refer to "1.2 Setup Preparation" (page 25)
for LAN connection properties setup information of the PC terminal.
The ETERNUS DX Disk storage system and the PC terminal must be connected directly since the network
environment of the ETERNUS DX Disk storage system is set using the PC terminal for the initial setup of the
ETERNUS DX Disk storage system.
Figure 5.1 PC terminal connection for initial setup
• When the LAN cable for the MNT port of Controller 0 (CM#0) is connected to a network device, connect the
cable to a PC terminal.
• Remove the LAN cable that is connected to the MNT port of Controller 1 (CM#1).
Controller enclosure
PC terminal
MNT port of Controller 0 (CM#0)
LAN cable
LAN port