Fujitsu Eternus DX90 S2 - Syslog Setup

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
122
12 Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
13 Send a test mail to confirm that e-mail messages can be sent to the e-mail addresses that
are set.
13-1 In [Action] on the [Network] screen, click [Setup E-Mail Notification].
The [Setup E-Mail Notification] screen appears.
13-2 Click the [Send Test E-Mail] button.
13-3 Check that the test mail is sent to the e-mail addresses that are set.
For details on the event code and message of the test mail, refer to "User's Guide -Operation-".
End of procedure
5.2.3 Syslog Setup
If an event occurs in the ETERNUS DX Disk storage system, logs for the event can be sent to the specified
syslog server (external server).
• Up to two syslog servers can be set.
• Make sure to check whether the syslog server receives logs correctly after the syslog notification
environment setup is complete.
• Logs are not sent again when a communication error occurs between the ETERNUS DX Disk storage
system and the syslog server.