Fujitsu Eternus DX90 S2 - SNMP Trap Setup

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
124
5.2.4 SNMP Trap Setup
SNMP Trap can be sent to the SNMP Manager (monitoring server) when an event occurs in the ETERNUS DX
Disk storage system.
The SNMP Trap setting is explained below.
■ ETERNUS DX Disk storage system settings
The SNMP Trap setting for the ETERNUS DX Disk storage system is explained below.
Procedure
1 Set up the network environment for the ETERNUS DX Disk storage system.
When the ETERNUS DX Disk storage system and the monitoring server are in different subnet
environments, set the Gateway IP address and the Allowed IP List (IP address of the monitoring server
or the network address to which the monitoring server belongs) on the [Setup Network Environment]
screen of ETERNUS Web GUI.
For details on the settings, refer to "ETERNUS Web GUI User's Guide".
The following screen shot shows an example of the settings when the [IPv4 Settings] tab is selected.
Carefully read this manual and the manuals that are supplied with the monitoring software (SNMP Manager)
that is to be used before monitoring the ETERNUS DX Disk storage system.