Fujitsu Eternus DX90 S2 - Page 125

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
125
2 Set up the SNMP environment.
2-1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2-2 In [Category], click [Network].
The [Basic] tab screen of the [Network] screen appears.
2-3 In [Action], click [Setup SNMP Agent Basic Interface].
The [Setup SNMP Agent Basic Interface] screen appears.
2-4 Select "Enable" for "SNMP Function", set the required items in the [Setup SNMP Agent Basic
Interface] screen, and click the [Set] button.
Select the LAN port that was set up in Step 1
for "LAN Port used for SNMP".
A confirmation screen appears.
2-5 Click the [OK] button.
The SNMP Agent basic settings are applied.
2-6 Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
3 Set up the SNMP Manager.
Set up the SNMP Manager (monitoring server) that is the destination of the SNMP Trap transmission.
3-1 In [Action], click [Setup SNMP Manager].
The [Setup SNMP Agent Manager] screen appears.
3-2 In the manager list of the [Setup SNMP Agent Manager] screen, click the [Add] button.
The [Manager] screen appears.
This step is not required when ETERNUS SF Storage Cruiser is used to monitor the ETERNUS DX Disk
storage system.