Chapter 5 Setup
5.5 System Status Check
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
143
5.5 System Status Check
Check the status of the ETERNUS DX Disk storage system on the ETERNUS Web GUI screen or ETERNUS CLI.
â– Component status check
The status of the ETERNUS DX Disk storage system can be checked by general status in the upper left of the
ETERNUS Web GUI screen.
When the general status image is " ", the ETERNUS DX Disk storage system is in normal status.
When the general status image is other than " " (" ", " ", etc.), an
abnormality has been detected in the ETERNUS DX Disk storage system. Check the status of each component
on the [Storage] screen.
To display the [Storage] screen, click the [Component] tab on the navigation of the ETERNUS Web GUI screen.
If there is a component in Warning or Error status, contact your sales representative or maintenance engineer.
This section explains the procedure for the system status check using ETERNUS Web GUI. For the ETERNUS DX
Disk storage system monitoring setup using ETERNUS CLI, refer to "ETERNUS CLI User's Guide".
To Next Page
Loading...
