Fujitsu Eternus DX90 S2 - Installing Controller Enclosure

Chapter 3 Rack Installation
3.2 Installing Controller Enclosure
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
52
3.2 Installing Controller Enclosure
This section describes how to install the controller enclosure in a rack.
Procedure
1 Attach the rack rails to the rack.
■ For the EMEA&I region
(1) Attach the 2U rack rail to the left rear rack pillar.
The M5 centering screws should be inserted in the 1st and 6th holes above the base line of the
controller enclosure.
CAUTION
Do Not
• Do not uninstall the drives that are installed by default or move them to any
other slot.
Contact your sales representative or maintenance engineer if drives that are
installed by default need to be uninstalled or moved to another slot.
M5 centering screws (10mm)
2U rack rail