Chapter 4 Connecting Cables
4.5 Power Cord Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
79
1 Connect the power cord to the ETERNUS DX Disk storage system.
1-1 Connect the power cord plugs to the power inlets of the power supply units.
1-2 Fasten the plug of the power cord with the release tie.
Wrap the release tie around the power cord and fasten the release tie from either side. Make sure
that the release tie is not loose.
Each enclosure has two power supply units (PSU#0 and PSU#1). The power cords must be connected
to the inlets of both power supply units.
To Next Page
Loading...
