U41578-J-Z875-1-76 49
RAID wizard
At this point the configuration settings are stored on the controller RAM.
The COD (Configuration on Disk) will be processed and written to each hard
disk at a later stage. This process can last quite a few minutes depending on the
size on the CODs generated.
If you closed the new configuration by pressing Finish, a prompt will be
displayed telling you that everything (including the COD) listed above and
present in the memory will be now be written to the hard disk drives. When
writing has finished, you should reset the system so that the configuration can
be stored on the controller. However, this reset procedure lasts some time and
will have a dramatic effect on the host connected up. You are therefore given the
choice at this point of carrying out the reset procedure now or postponing it until
later. For the reasons already given, we strongly recommend that you carry out
the reset procedure now.
After 2-5 minutes you will be informed that the controller has been resetted
normally. If this information is not displayed within 5 minutes, depending on
some HBA drivers, close Spheras, reset the HBA, and restart the Spheras
agents and Spheras itself over again.
To Next Page
Loading...
