Copyright 2011 – FUJITSU ISOTEC LIMITED
FP-1000 Installation Guide-2 1.1.0.0
19 of 57
b) When using a USB interface connection
The USB port may vary depending on your system configuration.
Use the following procedure to change the printer driver setting and confirm it by printing a test page.
(1) Use the following procedures to open the [Printers] or [Printers and Faxes] screen.
For Windows 7
• Click the
Windows logo button in the lower-left corner of the desktop screen.
• Click [Devices and Printers
].
For Windows Server 2008 R2
• Click [Start] [Devices and Printers].
For Windows Vista
• Click the
Windows logo button in the lower-left corner of the desktop screen.
• Click [Control Panel] [Hardware and Sound] [Printers].
For Windows Server 2008
• Click [Start] [Control Panel] [Hardware and Sound] [Printers].
For Windows XP Professional/Server 2003/WEPOS/WEPOS2009
• Click [Start] [Printers and Faxes].
For Windows XP Home Edition
• Click [Start] [Control Panel] [Printers and Other Hardware].
For Windows 2000
• Click [Start] [Settings] [Printers].
(2) Use the following procedures to open the property screen of "FIT FP-1000 Raster."
For Windows 7/Windows Server 2008 R2
• Right-click the "FIT FP-1000 Raster" printer and then click [Printer Properties].
For Windows Vista/Windows Server 2008
• Right-click the "FIT FP-1000 Raster" printer and then click [Run as administrator]
[Properties].
* If you have logged on using the Windows Server 2008 built-in administrator account,
right-click the "FIT FP-1000 Raster" printer and then click [Properties].
For Windows XP /Server 2003/WEPOS/WEPOS2009/2000
• Right-click the "FIT FP-1000 Raster" printer and then click [Properties].
To Next Page
Loading...
Need help?
General