− 78/83 −
12-2. Cutter Specifications
(1) Cutting Method: Partial cut (the paper remains connected at one point)
Caution: Do not use the cutter continuously at a rate exceeding 10 cuts
per minute (1 cut per 6 seconds or more). Excessive use may
cause a malfunction.
12-3. Paper Roll Supply Specifications
(1) Loading Method: Rolls are loaded manually.
(2) Paper Near End: Detected when the remaining paper length is inadequate.
Caution: Core diameter φ18mm is supported.
12-4. Interface Specifications
(1) Serial (RS-232C)
(2) USB (USB 2.0 Full-speed)
(3) LAN (10BASE/100BASE-T)
To Next Page
Loading...
