Fujitsu FP-510 - Page 121

120 / 125
(4) OTHER setup items
No. Item Explanation
Detail setup
item
1
ACK PULSE WIDTH
*2
- Specifies the ACK pulse width.
1
μ
s
8
μ
s
2
USB
- Specifies the use of the USB connection.
V-COM : Virtual COM class.
PRINTER : Printer class.
V-COM
PRINTER
3
SERIAL NUMBER
- Specifies the type of Serial Number notification in a
USB connection.
Generally, specify "DISABLE."
ENABLE
DISABLE
4
ERROR
- Specifies the mode for the power-on time and the
error recovery time.
AUTO RECOVERY : Windows drivers are used.
RECOVERY BY CMND : OPOS drivers are used.
AUTO
RECOVERY
RECOVERY
BY CMND
5
PROCESS ID
- Specifies a process ID.
NORMAL:
Responds with the process ID at the end of printing.
HI-SPEED: Responds with the process ID at
the end of data reception.
NORMAL
HI-SPEED
6
PNE DETECT
- Specifies whether to report the
Paper-near-end condition.
ENABLE
DISABLE
7
FONT B
- Specifies Font B.
MODE 1: Font in the standard specifications
MODE 2: FP-310 compatible font
MODE 1
MODE 2
8
BATCH (COM IF)
or
BATCH (BT IF) *3
- ENABLE:
Received data is printed in a batch.
- DISABLE:
Received data is printed serially.
* This item is valid only with the
Serial or Bluetooth interface.
ENABLE
DISABLE
9
BATCH (OTHER IF)
or
BATCH (USB IF) *3
- ENABLE:
Received data is printed in a batch.
- DISABLE:
Received data is printed serially.
* This item is valid only with the
USB ,Parallel or LAN interface.
ENABLE
DISABLE
10
CUTTER MODE
- Specifies the mode for cutter operation.
* This item is valid only for models
supporting both full cutting and partial
cutting.
PARTIAL
FULL
*2 This is not displayed in the case of Bluetooth and USB interface model.
*3 This is displayed in the case of Bluetooth and USB interface model.