Removing and installing components
during servicing
Preparing to remove components
If you are going to remove or change system c omponents, prepare for the removal as follows:
Please observe the safety information in chapter "Important notes", Page 15.
Remove the power plug from the mains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables
from t he device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to pre v ent the device from being scratched.
► Remove the battery
(see "
Removing a battery", Page 37).
64 Fujitsu
To Next Page
Loading...
