Removing and installing components
during servicing
Installing and removing memory
expansion
MemorymoduleMainmemoryRemovingmemorySystemexpansionSystem expansion
If you are aske d by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter "Important notes", Page 15.
When installing/removing memory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see "
Preparing to remove components", Page 64.
Only use memory expansion modules that have been approved f or your
notebook (see "
Technical data", Page 82).
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartment to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. Therefore, be sure to observe the following:
Individual components can become very hot during operation. T herefo re, we
recommend that you wait one hour after switching off the notebook before removing
or installing memory modu les. Otherwise, there is a risk of suffering burns!
As some compone nts are exposed that are sensitive to static electricity, please take
note of chapt er "
Notes on ins talling and removing boards and components", Page 63.
Removing memory modules
3
2
1
1
► Carefully push th e two mounting
clips outwards (1).
Memoryexpan
sion
Memorymodul
e
The memory module snaps upwards (2).
► Pull the memory m odule out of its slot
in the direction of the arrow (3).
66 Fujitsu
To Next Page
Loading...
