Troubleshooting and tips
The radio connection to a networ
kdoesnotwork
Theradioconn ectiontoane tworkdoesnot work
(Possible) Cause Troubleshooting
The wireless component is disa
bled.
► Switch the rad io component on (see
"
Switch ing the wireless components on and
off", Page 4 6).
The wireless component is enabled. Despite
this, the wireless connection to a n etwork does
not work.
► Check whether the radio connection is
switched on via the software.
► Further information on using the radio
component can be found in the help files.
Acoustic warnings
Acousticerror messagesErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is almost flat.
► Charge the battery.
SmartCard reader is not recognized
Cause
Troubleshooting
Chip card inserted incorrectly.
► Make sure you have inserted your
SmartCard into the SmartCard reader with
the chip facing upwards.
► Check whether the SmartCard yo u are using
is supported. Your SmartC ard must c omply
with the ISO standard 7816-1, -2, -3 and -4.
SmartCard PIN forgotten
Cause
Troubleshooting
PIN forgotten ► If you are working in a network, contact your
system administrator, who can unlock your
notebook with a Supervisor PIN.
SmartCard lost
Cause
Troubleshooting
SmartCa
rd lost
► If you ar
e working in a network, contact your
system a
dministrator, who can boot up your
notebo
ok with a Superviso r SmartCard.
80 Fujitsu
To Next Page
Loading...
