Fujitsu lifebook e746 - Error messages on the screen

Tro ubl eshooting and tips
Error messages on the screen
Errormessages onthescreenErrormessage:
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the relevant documentation.
If the error m essage appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occurs repeate dly, the
buffer battery in the notebook is flat.
► Contact your sales outlet
or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system confi gurat ion info rmation is
incorrect.
► Switch t he notebook of
f.
► Switch t he notebook on.
► Press the function k
ey
F2
to access the
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Lo
ad Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failin g Bits:
zzzz zzzz
When testing the extended memory an e rror has
resulted at the address xxxx.
► Check whether the a dditional me mory
module has been inse rted correctly.
Failure Fix ed Disk n
The s ettings of the hard disk drive are i ncorrect.
► Start the BIO S Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
► Switch the notebook off with the Power
ON/OFF button.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an e xternal keyboard:
► Check the connection and r eboot the
notebook.
nn Stuck key
► Make sure that no key is pressed.
Operating system not found
► Check
in the BIOS Setup whether your hard
disk h
as been set correctly.
► Make sure that the o p e rating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This erro r message appears if an error occurs
during the self-test before starting the operating
system.
► Press the
F1
function key to s tar t the
operating system.
► Press the function key
F2
to access the
BIOS Setup.
Fujitsu 81