Appendix
Methods for accessing the utilities
Recovery and Utility Tools are preinstalled in a hidden partition by the factory, or
they can be accessed by using the bootable disc.
Note: The Recove ry and Utility tools m ay be deleted f rom your hard disk drive if yo u modify the
partitions. If that occurs, you will no t be able to use the hidden partition for booting to Recovery
and U tility Tools, but you will still be able to boot from the Bootable Disc.
Determining whether R ecovery an d Util ity is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. U se the
Tab
key to get to the A pplication Menu.
3. C heck whether the Recovery and Util ity option is present. If it is not present, it means that
the utility m ust be used from the Bootable Disc. Proceed to the "“Ru nning Recovery and
Utility from the Bootable Disc”"section if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. U se the
Tab
key to get to the A pplication Menu.
3. Mo ve the cursor down to R e covery and Utility and press the
Enter
key.
4. C hoose your language, if necessary. Select Recovery and Utility to proceed.
5. T h ree tool options appear: Diagnostics, Recovery, and Utility (refer to the" Recovery and
Utility tools "section below for instructions on how to use these tools).
6. If this was successful please skip the next step and go to the "Recovery and Utility too ls" section.
7. If this was NOT successful, p lease go to the next step.
Running Recovery and Utility from the Bootable Disc
Note: If your system does not have an internal writable DVD drive, connect
your system to an external drive.
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Pow er o n your system. When the Fujitsu logo appears on the screen, press the
F12
key.
2. Insert the bootable disc into the drive tray.
3. H ighlight the CD/DVD option from the Boot menu, then p ress
Enter
.
4. Click OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicable then press
Enter
.Whilethe
files are being loaded from the disc, the Fujitsu logo screen will appear followed
by a progress bar at the bottom of the screen.
Recovery and Utility tools
Note: Re covery an d Utility tools may not be available on your system depending
on the regio n from wh ich the system was shipped .
Diagnostics tool: The Diagnostics tool is designed for use by IT professionals. It is not likely you
will need to use this tool. If you should need to use this tool, perform the following steps:
1. Press the D iagnostics Toolbutton to start the Diagnostics tool.
2. R ead the note, and then click OK.
98 Fujitsu
To Next Page
Loading...
