Contents
x C156-E228-02EN
3.1.1 Temperature measurement points........................................................3-1
3.1.2 Temperature requirements...................................................................3-2
3.1.3 Temperature rise..................................................................................3-3
3.1.4 Air flow ...............................................................................................3-4
3.1.5 Air cleanliness.....................................................................................3-4
3.2 Mounting Requirements ...........................................................................3-4
3.2.1 Outer dimensions.................................................................................3-4
3.2.2 Installation direction..........................................................................3-10
3.2.3 Center of gravity................................................................................3-11
3.2.4 Precautions on mounting...................................................................3-12
3.3 Power Supply Requirements...................................................................3-14
3.4 Connection Requirement ........................................................................3-17
3.4.1 Connectors and terminals..................................................................3-17
3.4.2 Cable connection requirements .........................................................3-19
3.4.3 External operator panel .....................................................................3-20
3.4.4 External operator panel settings (CNH2)..........................................3-23
CHAPTER 4 Installation ...............................................................................4-1
4.1 Notes on Drive Handling..........................................................................4-1
4.2 Connection Modes....................................................................................4-4
4.3 Settings......................................................................................................4-5
4.3.1 Setting switches (SW1) .......................................................................4-7
4.3.2 Setting of supplying power to SCSI terminating resistor..................4-10
4.3.3 SCSI terminating resistor mode.........................................................4-11
4.4 Mounting.................................................................................................4-12
4.4.1 Checks before mounting the drive.....................................................4-12
4.4.2 Mounting procedure ..........................................................................4-13
4.5 Cable Connections..................................................................................4-13
4.6 Operation Confirmation and Preparation for Use after Installation .......4-14
4.6.1 Confirming initial operations ............................................................4-14
4.6.2 SCSI connection check......................................................................4-15
4.7 Dismounting Drive..................................................................................4-17
To Next Page
Loading...
