C156-E228-02EN IN-1
Index
128 MB media 2-10
1.3 GB media 2-11
230 MB media 2-10
25.4 mm height 1-1
540 MB/640 MB media 2-10
A
ACK 7-5
actuator section 1-8
adaptability 1-3
air cleanliness 3-4
algorithm for alternate processing 2-11
allowable input voltage and current 3-14
appearance 1-6, 2-8, 5-6
appearance of
optical disk cartridge 5-7
optical disk drive 5-1
ARBITRATION phase 7-20, 7-21
asynchronous transfer 7-28
ATN 7-5
ATTENTION 7-5
ATTENTION condition 7-40
Australian EMC standard 1-4
automatic allocation of alternate data block
1-3
automatic spindle stop function 1-2
B
bit error rate after ECC processing 2-5
block diagram of control circuit section 1-9
BSY 7-4
bus condition 7-40
BUS FREE phase 7-18
bus phase 7-18
sequence 7-46, 7-47
bus sequence 7-45
BUSY 7-4
C
cable connection 4-13
mode 3-19
requirement 3-19
cable side 7-7
Canada safety standard 1-4
cartridge case 2-9
catalog 2-1
C/D 7-5
CDRH 1-4
center of gravity 3-11
change of revision number in field 6-4
checking panel function 3-13
checks before mounting the drive 4-12
checks if errors occur at initial self-diagnosis
4-14
cleaning 5-1
kit 5-10
optical disk cartridge 5-10
tool for optical disk cartridge 5-10
cleaning of
disk surface 5-14
optical disk cartridge 5-11
optical disk drive 5-5
COMMAND phase 7-33
compatibility with international standard
(media interchangeability) 1-2
configuration 1-7
optical disk drive 1-6, 1-7
confirming initial operation 4-14
conformation to SCSI-2 1-4
connecting
one optical disk drive 4-4
more than one optical disk drive 4-4, 4-5
connection
mode 4-4
of interface cable 7-10
requirement 3-17
connection to
middle point of cable 7-10
end of cable 7-10
connector 3-17
connector and terminal location 3-17
continuous block processing 1-4
control circuit section 1-8
CONTROL/DATA 7-5
CSA C22.2 No. 950 1-4
current waveform
(+5 VDC) 3-14
(reference) 3-14
To Next Page
Loading...
