Fujitsu MCM3064SS - Page 19

Contents
C156-E228-02EN xv
TABLES
Table 2.1 Representative model names and order numbers .......................2-1
Table 2.2 Specifications..............................................................................2-2
Table 2.3 Environmental and power requirements .................................... 2-4
Table 2.4 Recommended optical disk cartridges........................................2-7
Table 2.5 Disk specifications.................................................................... 2-10
Table 3.1 Temperature requirements at measurement points.....................3-2
Table 3.2 Temperatures at measuring points (Reference).......................... 3-3
Table 3.3 Recommended components for connection.............................. 3-20
Table 3.4 External operator panel interface..............................................3-22
Table 3.5 Device type mode setting..........................................................3-23
Table 3.6 Write verify mode setting .........................................................3-23
Table 3.7 Logical specification type setting .............................................3-24
Table 4.1 SCSI ID setting (SW1)................................................................4-8
Table 4.2 SCSI data bus parity checking (SW1) ........................................4-8
Table 4.3 Write cache mode setting............................................................ 4-9
Table 4.4 Device type mode settings..........................................................4-9
Table 4.5 Spindle automatic stop mode setting........................................4-10
Table 4.6 SCSI terminating resistor power supply (CNH1)..................... 4-10
Table 4.7 SCSI terminating resistor mode (CNH1).................................. 4-11
Table 4.8 Setting checklist........................................................................4-12
Table 5.1 Head cleaner................................................................................5-5
Table 5.2 Cleaning kit...............................................................................5-10
Table 5.3 Packing list for cleaning kit ......................................................5-10
Table 6.1 Diagnostics function ...................................................................6-1
Table 7.1 INFORMATION TRANSFER phase identification................... 7-5
Table 7.2 Interface cable requirements.......................................................7-9
Table 7.3 Requirements for terminating resistor power supply................7-12
Table 7.4 Signal status ..............................................................................7-13
Table 7.5 Signal driving method...............................................................7-13
Table 7.6 Bus phases and signal sources .................................................. 7-14
Table 7.7 Timing specifications ............................................................... 7-15
Table 7.8 SCSI BUS Timing specifications..............................................7-17
Table 7.9 Parameters used for synchronous data transfer ........................7-35
Table 7.10 Setting value of SCSI time monitoring..................................... 7-39