8
FCC warning: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Canadian DOC Regulations
This digital apparatus does not exceed the Class B limit
for radio noise emissions from digital apparatus set out in
the Radio interference Regulations of the Canadian
Department of Communications.
This Class B digital apparatus complies with Canadian
ICES-003.
Le présent appareil numérique n'émet pas de parasites
radioélectriques dépassant les limites applicables aux
appareils numériques de la classe B et prescrites dans le
Règlement sur le brouillage radioélectrique dictées par le
Ministère des Communications du Canada.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
Bescheinigung des Herstellers/
Importeurs
Für den Scanner wird folgendes bescheinigt:
In Übereinsstimmung mit den Bestimmungen der
EN45014(CE) funkentstört
Maschinenlärminformationsverordnung 3. GPSGV:
Der höchste Schalldruckpegel beträgt 70 dB (A) oder
weniger, gemäß EN ISO 7779.
Dieses Gerät wurde nicht für die Benutzung in
unmittelbarer Umgebung starker Lichtquellen (z. B.
Projektoren) konzipiert.
ENERGY STAR
®
PFU Limited, a Fujitsu company, has
determined that this product meets the
ENERGY STAR
®
guidelines for energy
efficiency. ENERGY STAR
®
is a
registered trademark of the United
States.
Use in High-safety Applications
This product has been designed and manufactured on
the assumption that it will be used in office, personal,
domestic, regular industrial, and general-purpose
applications. It has not been designed and manufactured
for use in applications (simply called "high-safety
applications" from here on) that directly involve danger to
life and health when a high degree of safety is required,
for example, in the control of nuclear reactions at nuclear
power facilities, automatic flight control of aircraft, air
traffic control, operation control in mass-transport
systems, medical equipment for sustaining life, and
missile firing control in weapons systems, and when
provisionally the safety in question is not ensured. The
user should use this product with adopting measures for
ensuring safety in such high-safety applications. PFU
LIMITED assumes no liability whatsoever for damages
arising from use of this product by the user in high-safety
applications, and for any claims or compensation for
damages by the user or a third party.
■ Failure and Repair
If repairing the scanner or replacing parts is required, an
abnormal change is detected, or other problems which
indicate a scanner failure are detected, first, refer to
"Appendix A Troubleshooting" (page 18) in this manual
or "Troubleshooting" of the Operator's Guide to check
that the scanner is correctly connected or configured. If
the problem still persists, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service
provider.
The user must not perform repairs on the scanner.
PFU assumes no liability for any damage caused by
taking apart the scanner, as doing so is not covered
under the warranty.
NOTICE The use of a shielded interface cable is
required to comply with the Class B limits of
Part 15 of FCC rules. The length of the
power cable must be 3 meters (10 feet) or
less.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
