BX900S2 Operating Manual 105
8 Troubleshooting and tips
V CAUTION!
Follow the safety instructions in the "Safety notes and regulations"
manual or " 安全上のご注意 " and in chapter "Important information" on
page 35.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the connected devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
8.1 System power indicator does not light up
The system's power indicator (see figure 16 on page 69) does not light up after
you have switched on your system:
Power cable not connected correctly
Ê Make sure that the power cable is correctly connected to the system's power
supply units and to the socket strip of the rack (see section "Connecting the
system unit to the mains" on page 61).
Power supply overloaded
Ê Unplug the power cables from the insulated sockets of the power supply
units.
Ê Wait a few seconds and then plug the power cables back into the sockets.
Ê Switch on your system.
To Next Page
Loading...
