BX900S2 Operating Manual 43
Important information
● Before connecting or disconnecting cables, read the notes in the chapter
"Important Notes" in the technical manual for the relevant rack. The
technical manual for the rack is supplied with the rack.
● The rack must be connected to the mains by an authorized specialist
(electrician).
● If the server system is integrated in a rack installation that receives power
from an industrial (public) power supply network with the IEC309 connector,
the (public) power supply protection must comply with the requirements for
the non-industrial (public) power supply networks for the type B connector.
● The power supply for the rack should be distributed over the three phases
of a three-phase mains connection.
Other important information:
● During cleaning, observe the instructions in section "Cleaning the system
unit" on page 102.
● Keep this operating manual and the other documentation (such as the
technical manual, documentation DVD) close to the device. All
documentation must be included if the equipment is passed on to a third
party.
4.2 CE conformity
4.3 FCC Class A Compliance Statement
If there is an FCC statement on the device, it applies to the products covered in
this manual, unless otherwise specified herein. The statement for other
products will appear in the accompanying documentation.
The system complies with the requirements of the EC directives
2004/108/EC regarding "Electromagnetic Compatibility" and
2006/95/EC "Low Voltage Directive". This is indicated by the CE
marking (CE = Communauté Européenne).
To Next Page
Loading...
