Fujitsu Primergy BX900 S2 - Transporting and Installing the System Unit; Notes on Installation into the Rack

42 Operating Manual BX900S2
Important information
© cognitas. Gesellschft für Technik-Dokumentation mbH 2012 Pfad: C:\Programme\FCT\tim_app\tim_local\work\WALTER\OBJ_DOKU-13568-001.fm
Transporting the system unit
● Only transport the system unit in its original packaging or in suitable
packaging which protects it from knocks and jolts.
For the Japanese market, transporting the device in its original packaging
does not apply.
Only unpack the system unit at the place where you want to set it up.
● Ask someone for help with carrying the system unit. Because the
PRIMERGY BX900 S2 system unit is large and heavy, at least 3 people are
needed.
● Before lifting the system unit, remove all server blades, storage blades,
connection blades, management blades, all power supply units, fan
modules and dummy modules units to reduce the weight.
● To lift or carry the system unit, mount the handles on the long sides of the
unit.
● Only lift or carry the system unit by the handles on the long sides.
● Never lift or carry the system unit by the handles on the front or back.
Notes on installation into the rack
● For safety reasons, at least 3 people are required to install the system
unit in the rack because of its weight and size.
(For the Japanese market, please refer to " 安全上のご注意 ".)
● Before lifting the system unit, remove all server blades, storage blades,
connection blades, management blades, all power supply units, fan
modules and dummy modules to reduce the weight.
● To lift or carry the system unit, always use the handles on the long sides.
● Never lift or carry the system unit by the handles on the front or back of the
unit.
● For safety reasons, no more than one unit may be removed from the rack at
any one time during installation or maintenance work.
● Make sure that the anti-tilt plate is correctly mounted when you set up the
rack.
● The rack may tip over if more than one unit is removed at the same time.