Fujitsu PRIMERGY BX900 - Page 35

22 Brocade 5450 Hardware Reference Manual
53-1001266-02
Setting the Embedded Switch Module IP address
3
2. Use the following Telnet menu options to change the IP address of the selected Embedded
Switch Module.
a. Select (3) Console Redirection from the following Console Menu.
--------------------------------
Console Menu
--------------------------------
(1) Management Agent
(2) Emergency Management Port
(3) Console Redirection
(4) TFTP update
(5) Logout
(6) Reboot Management Blade
(7) System Information Dump
(8) Command Line Interface
(9) Account Management
Enter selection: 3
b. Select (1) Console Redirect Connection Blade from the following Console Redirection
Table.
--------------------------------
Console Redirection Table
--------------------------------
(1) Console Redirect Connection Blade
(2) Set Return Hotkey , Ctrl+(a character) : Q
(3) Set Console Redirection Timeout : 900
Enter selection or type (0) to quit: 1
c. Select the location where the switch is installed from the following menu.
-------------------------------------
Console Redirect Connection Blade
-------------------------------------
(2) Console Redirect Connection Blade-2 (Selected:Backup/Restore)
(3) Console Redirect Connection Blade-3
(4) Console Redirect Connection Blade-4
(5) Console Redirect Connection Blade-5
(6) Console Redirect Connection Blade-6
Enter selection or type (0) to quit: 5
You should now be at the switch login prompt.
3. Verify that you are able to login to the switch:
Login: admin
Password: <default admin login password>
4. Enter the ipaddrset command to set the IP address.