Fujitsu PRIMERGY BX900 - Appendix A Embedded Switch Module Specifications; In this Appendix; Access Gateway Mode Default Port Mapping

Brocade 5450 Hardware Reference Manual 41
53-1001266-02
Appendix
A
Embedded Switch Module specifications
In this appendix
•Access Gateway Mode default port mapping . . . . . . . . . . . . . . . . . . . . . . . . 41
•Processor and memory specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
•Weight and physical dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
•Facility requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
•Electrical. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
•Architectural specification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
•Fibre Channel standards compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
•Regulatory compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
•Environmental regulation compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
Access Gateway Mode default port mapping
The Embedded Switch Module can contain 26 total ports. Of these, F_Ports are ports 1-18 and
N_Ports are ports 0 and 19-25.
The following lists the factory-default F_Port to N_Port mapping for Access Gateway mode.
NOTE
All ports have failover and failback enabled.
• 1, 2, and 17 mapped to 19
• 3, 4, and 18 mapped to 20
• 5, 6 mapped to 21
• 7, 8 mapped to 22
• 9, 10 mapped to 23
• 11, 12 mapped to 24·
• 13, 14 mapped to 25
• 15, 16 mapped to 0
• 19-25 and 0 as N_Port
For more information on changing port mapping and managing ports in Access Gateway Mode,
refer to the Access Gateway Administrator’s Guide.