Fujitsu PRIMERGY BX900 - Disabling Access Gateway Mode Using the CLI

Brocade 5450 Hardware Reference Manual 31
53-1001266-02
3
Disabling Access Gateway mode using the CLI
Disabling Access Gateway (AG) mode is disruptive because the switch is disabled and rebooted.
Disabling AG mode clears the F_Port to N_Port mapping. Always back up the current configuration
before enabling or disabling Access Gateway mode.
For additional information on reconfiguring a switch and joining it to a fabric, see the Fabric OS
Administrator’s Guide.
Complete the following steps to disable Access Gateway mode using the CLI.
1. Connect to the Embedded Switch Module and log in as admin.
2. Enter the ag --modeshow command to verify that the Embedded Switch Module is in AG mode.
3. Enter the switchDisable command to disable the Embedded Switch Module.
NOTE
To save the Access Gateway configuration, use the configUpload command before proceeding
with the next step.
4. Enter the ag --modedisable command to disable AG mode.
The switch automatically reboots and comes back online using the fabric switch configuration.
The AG parameters, such as F_Port to N_Port mapping, and the Failover and Failback policies,
are automatically removed.
5. Enter the ag --modeshow command to verify that AG mode is disabled.