Fujitsu PRIMERGY BX900 - Enabling Access Gateway Mode Using Web Tools

Brocade 5450 Hardware Reference Manual 29
53-1001266-02
Changing from Fabric OS Native to Access Gateway mode
3
Configure your Embedded Switch Module to run in Access Gateway mode using the following
instructions. You can log into the Embedded Switch Module and enable Access Gateway mode
using either Web Tools or the Embedded Switch Module CLI.
NOTE
Refer to the Access Gateway Administrator’s Guide for the latest information on configuring in
Access Gateway mode.
Enabling Access Gateway mode using Web Tools
Complete the following steps to enable Access Gateway mode using Web Tools.
1. Open a Web browser from the management console.
2. Enter the IP address of the Embedded Switch Module into the Address field of the Web
browser.
See the Web Tools Administrator’s Guide for more information on using Web Tools.
3. Log into Web Tools using the default administrative account.
Login: admin
Password: password
4. Select the Embedded Switch Module from the fabric tree.
The selected Embedded Switch Module appears in the Switch View.
5. Click the Switch Admin button in the WebTools Manage taskbox.
The Switch Administration window opens.
NOTE
You should save the configuration file if you are converting an Embedded Switch Module to
Access Gateway mode. To save your current configuration, click the Show Advanced Mode
button in the top right-hand corner of the Switch Administration window. Select the Configure
tab, then select the Upload/Download tab. Enter the relevant information to upload the
configuration file.
6. From the Switch Status section, click Disable.
7. From the Access Gateway Mode section, click Enable.
8. Click Apply.
9. When prompted, click Yes to restart the Embedded Switch Module in Access Gateway mode.
The current Web Tools session closes; relaunch Web Tools after the Embedded Switch Module
reboots.