Fujitsu PRIMERGY LTO3 - Page 62

62
• When using a CD such as ServerStart
• For Windows Server 2003 / SBS 2003
[CD-ROM drive]:\DRIVERS\tape\LTO3\drivers\WinNT\Win2003\i386
• For Windows Server 2003 x64
[CD-ROM drive]:\DRIVERS\tape\LTO3\drivers\WinNT\Win2003\x64
10 Click [Next].
The "Completing the Hardware Update Wizard" message appears.
11 Click [Finish], and click [Close].
12 Restart the server.
For Windows 2000 Server
1
Log on to the Windows 2000 Server with administrator privileges.
2 Click the [Start] button → [Settings] → [Control Panel] in this
order.
3 Double click the [System] icon.
4 Select the [Hardware] tab and click [Device Manager].
5 Double click [Other devices], and then double click [HP Ultrium 3-
SCSI SCSI Sequential Device].
6 Select the [Driver] tab and click [Update Driver].
The "Welcome to the Device Driver Upgrade Wizard" message appears.
7 Click [Next].
8 Select [Find the best driver for the device], and click [Next].
9 Select [Specify the location], click [Next], set in the copy source
as follows, and click [OK].
• When using the supplied driver floppy disk (or when a downloaded driver has been
restored to a floppy disk)
A:\drivers\WinNT\Win2000
• When using a CD such as ServerStart
[CD-ROM drive]:\DRIVERS\tape\LTO3\drivers\WinNT\Win2000
The "The following device driver is found" message appears.
10 Click [Next].
The "Completing the Device Driver Upgrade Wizard" message appears.
11 Click [Complete], and click [Close].