1 Installing the Unit to a Server 63
E
12 Restart the server.
1.3.2 Driver Installation (For PRIMERGY FT)
Notes
• This product can be installed only to FT1. It cannot be installed to FT2.
• Two of this product cannot be installed at the same time.
• This product cannot be used from CoServer.
• The FT model cannot restore the system using Automated System Recovery (ASR) set or system
recovery disk. For restoration, use the recovery CD supplied with the server.
• For installation of the internal 5-inch option, refer to the User’s Guide of the FT model.
For Windows Server 2003
1
Install this product to FT1.
2 Turn on the power of FT1 and FT2, and start the CoServer in online
mode.
3 Log on to the CoServer1 with administrator privileges.
4 Click the [Start] button → [Control Panel] → [System] in this order.
5 Select the [Hardware] tab and click [Device Manager].
The device manager starts.
6 Double click [Other devices], and then double click [HP Ultrium 3-
SCSI SCSI Sequential Device].
7 Select the [Driver] tab and click [Update Driver].
The Setup Wizard appears.
8 When the "Can Windows connect to Windows Update to search for
software?" message appears, click [No, not this time] and then
click [Next].
Follow the wizard for installation.
9 For installation methods, click [Install from a list or a specific
location] and click [Next].
10 For search and installation options, select [Search for the best
driver in these locations] and set the following options.
1. Uncheck [Search removable media (floppy disk, CD-ROM, etc.)].
2. Check [Include this location in the search] and specify the folder which restored
the driver.
• When restored in the floppy disk drive A
A:\drivers\WinNT\Win2003\i386
To Next Page
Loading...
