RX300 S3 Service Supplement 31
Replacement routines Replacing the SAS backplane/expander board
Installing the SAS backplane/expander board
Figure 20: Attaching the insulation foil
Ê Attach the insulation foil as shown in the picture.
I The insulation foil is only necessary for the 3.5“ Hdds.
Figure 21: Inserting the SAS backplane
Ê Insert the backplane tilted behind the two sheets.
I Make sure that The SAS backplane will engage into the 12 guiding
points.
Further installation takes place in reverse order.
I Route the SMB cable from IDTemp Combo according to figure “Routing
the SMB cable for 3.5“ HDDs” on page 44 oder figure “Routing the SMB
cable for 2,5“ HDDs” on page 45.
To Next Page
Loading...
