Fujitsu Primergy RX300 S3 - Configuration Diagram; 14.2.1 Configuration with 3.5 Hdds

108 Options Guide RX300 S3
Configuration diagram Appendix
14.2 Configuration diagram
14.2.1 Configuration with 3.5“ HDDs
Figure 91: Part of the system configurator 3.5“ HDD
board front side
middle
Channel 0 (2 Modules) Bay for LocalView LCD
Xeon DP or 3.5"x 0,5" Floppy disk
Channel I (2 Modules)
Channel II (2 Modules) Air channel
Xeon DP
Channel III (2 Modules)
Bay for 5,25"x 0,5" IDE-CD
or DVD-ROM
Memory ( III ) Processor ( II )
Accessible drives ( V )
rear side
Fan 1 - Fan 4
1. PSU 2. PSU
Needs space for 2
hard disk drives!
Fan 5 - Fan 8 3.5"x1,6"
Redunda nt syste m-
Redundant power fans option Backup drive option
supply option
Hard disk drives ( VI )
RAID 5 support
Licence key + 256MB Cache
left side
onboard
Licence key + 256MB Cache+BBU
Extension slots for 3.5"x1" SAS or SATA
SCSI Controller ( VII )
Disk Array ( VIII )
Communication/Network ( IX ) 3.5"x1" SAS or SATA
Miscellaneous ( X )
RISER option
Slot 5: PCIe x8, Low Profile 3.5"x1" SAS or SATA
Slot 6: Slot 7: Slot 8:
HOT PLUG
Slot 4: PCIe x4, Low Profile (mech. x8)
right side
PCI-X 64 PCI-X 64 PCI-X 64
HOT PLUG
Slot 3: PCIe x4, Low Profile (mech. x8) 3.5"x1" SAS or SATA
133 MHz 133 MHz 133 MHz
Slot 2: PCI-X 64-Bit / 133MHz, Low Profile 3.5"x1" SAS or SATA
Standard Standard Standard
Slot 1: PCI-X 64-Bit / 133MHz, Low Profile 3.5"x1" SAS or SATA
shortshortlong
All low profile slots are covered, if PCI-riser card configured